Articles
  • Experimental investigation and optimization for surface roughness for turning of AISI 1040 steel
  • Seenivasan Murugesana,*, Venugopal Thangamuthua, Rohokale Milind Shivajib and Suresh Kumar Rc

  • aProfessor, Mechanical Engineering, KGISL Institute of Technology, Coimbatore, India
    bProfessor, Mechanical Engineering, SKN Sinhgad Institute of Technology & Science, Lonavala, India.
    cProfessor, Mechanical Engineering, Sri Eshwar College of Engineering, Coimbatore, India

  • This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

Abstract

In turning operation the effectiveness of the process is completely governed by the selection of the proper tool and its geometry. The right selection of tool geometry will provide optimized turning process parameters for minimizing the surface roughness. This work focuses on optimization of the surface roughness using response optimization while turning AISI1040 steel. Tool inserts are used to position the cutting tool and the tool geometries are considered as the process parameters. The minimization of the surface roughness is considered. 27 experiments are conducted and the surface roughness is measured and optimized using the taguchi technique. The main effects plots and ANOVA table are discussed in this work. Also response optimization is carried out and the composite desirability is determined and analysed


Keywords: AISI 1040, Tool geometry, ANOVA, Taguchi, Optimization, Surface quality

This Article

  • 2022; 23(3): 367-372

    Published on Jun 30, 2022

  • 10.36410/jcpr.2022.23.3.367
  • Received on Jan 25, 2022
  • Revised on Mar 10, 2022
  • Accepted on Mar 22, 2022

Correspondence to

  • Seenivasan Murugesan
  • Professor, Mechanical Engineering, KGISL Institute of Technology, Coimbatore, India
    Tel : +91 98422 39522

  • E-mail: drmseenivasan@gmail.com